Pioneer DEH-P4400R Initial Settings, Adjusting initial settings, Switching auto PI seek

Section

08Initial Settings

Adjusting initial settings Setting the FM tuning step

1

Initial settings lets you perform initial set up of different settings for this unit.

1FUNCTION display

Shows the function status.

1Press SOURCE and hold until the unit turns off.

2Press FUNCTION and hold until FM STEP appears in the display.

3Press FUNCTION to select one of the initial settings.

Press FUNCTION repeatedly to switch between the following settings:

FM STEP—A-PI—WARN—AUX—DIMMER—FRT+REAR—HANDS-F—TEL—TEL-SRC Use the following instructions to operate each particular setting.

•To cancel initial settings, press BAND/ESC.

•You can also cancel initial settings by holding down FUNCTION until the unit turns off.

Normally the FM tuning step employed by seek tuning is 50 kHz. When AF or TA are on the tun- ing step automatically changes to 100 kHz. It may be preferable to set the tuning step to 50 kHz when AF is on.

1Press FUNCTION to select FM STEP.

Press FUNCTION repeatedly until FM STEP appears in the display.

2Select the FM tuning step with 2/3. Pressing 2/3 will switch the FM tuning step between 50 kHz and 100 kHz while AF or TA is on. The selected FM tuning step will appear in the display.

Note

•The tuning step remains at 50 kHz during manual tuning.

Switching auto PI seek

The unit can automatically search for a different station with the same programming, even dur- ing preset recall.

1 Press FUNCTION to select A-PI.

Press FUNCTION repeatedly until A-PIappears in the display.

2 Select A-PIon or off with 5/∞.

Pressing 5/∞ will switch A-PIbetween on and off and that status will be displayed (e.g., A-PI :ON).

36En