Pioneer DEH-P4400RB operation manual Switching the warning tone, Switching the auxiliary setting

Initial Settings

Switching the warning tone

If the front panel is not detached from the head unit within five seconds of turning off the igni- tion, a warning tone will sound. You can turn off this warning tone.

1Press FUNCTION to select WARN.

Press FUNCTION repeatedly until WARN appears in the display.

2Select WARN on or off with 5/∞. Pressing 5/∞ will switch WARN between on and off and that status will be displayed (e.g.,

WARN :ON).

Switching the auxiliary setting

It is possible to use auxiliary equipment with this unit. Activate the auxiliary setting when using auxiliary equipment connected to this unit.

1 Press FUNCTION to select AUX.

Press FUNCTION repeatedly until AUX appears in the display.

2 Select AUX on or off with 5/∞.

Pressing 5/∞ will switch AUX between on and off and that status will be displayed (e.g., AUX :ON).

Switching the dimmer setting

To prevent the display from being too bright at night, the display is automatically dimmed when the car’s headlights are turned on. You can switch dimmer on or off.

Section

08

1 Press FUNCTION to select DIMMER.
Press FUNCTION repeatedly until DIMMER	English
appears in the display.
2 Select DIMMER on or off with 5/∞.
Pressing 5/∞ will switch DIMMER between on
and off and that status will be displayed (e.g.,
DIMMER :ON).
Switching the rear output setting	Español
This unit’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker or subwoofer connection. If you	Deutsch
switch the rear output setting to the subwoofer,
you can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
• If you connect a subwoofer to the rear output,
set the output setting to subwoofer.
• Even if you change this setting, there is no
output unless you switch the subwoofer output
on (refer to Using subwoofer output on page 34).	Français
ting.
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this set-
1 Press FUNCTION to select the rear output
setting mode.
Press FUNCTION repeatedly until FRT+REAR	Italiano
subwoofer then FRT+S/W will be displayed.
appears in the display.
• If the rear output setting has been set to the
2 Select full-range speaker or subwoofer
with 2/3.
Pressing 2/3 will switch between FRT+REAR	Nederlands
(full-range speaker) and FRT+S/W (subwoofer)
and that status will be displayed.

En 37