Runco LS-10I operation manual Serial Command Key Names and IR Codes, Some key command examples

External Control

Key Commands: The syntax for key commands is simple:

ky <keyname>[CR]
Some key command examples:
ky menu[CR]		Bring up or cancel menu display.
ky	mem.sw[CR]	Switch to next user memory.
ky	asp.16.9[CR]	Apply 16:9 aspect ratio.

The response from the projector for key commands will be the same command in

UPPERCASE.

Input: ky mem.sw[CR]

Response: KY MEM.SW [CR]

Table 6-1lists the serial command key names and IR codes. Use the IR codes to program a third-party remote control unit.

Table 6-1. Serial Command Key Names and IR Codes

IR Code	RS232	Remote Button	Description
	Keyname

0x00	pow.on	ON	Turn power on. If the projector is already on, this
			toggles the input panel backlight.
0x45	pow.off	OFF	Turn power off.
0x02	src.video	VID	Switch the active source to Video.
0x1f	src.svid	S-VID	Switch the active source to S-Video.
0x0a	src.hdmi1	HDMI 1	Switch the active source to HDMI 1.
0x50	src.hdmi2	HDMI 2	Switch the active source to HDMI 2.
0x1e	src.1	HD 1	Perform action assigned by user to HD 1 button
			(switch active source or change PIP state).
0x40	src.2	HD 2	Perform action assigned by user to HD 2 button
			(switch active source or change PIP state).
0x58	src.3	HD 3	Perform action assigned by user to HD 3 button
			(switch active source or change PIP state).
0x1b	info	INFO	Bring up an information box with the first seven (7)
			items in the Service menu.
0x19	menu	MENU	Bring up or cancel menu display.
0x5c	exit	EXIT	Exit all menus.
0x51	enter	ENTER	Keypad enter. If PIP is active and no menu is
			present then this executes the PIP swap function.

76 Runco LS-10i Installation/Operation Manual