Runco LS-10I operation manual op <operation> <command>CR

External Control

Operations Commands: Operations commands allow more flexible and direct control of the projector. The syntax for operations commands is as follows:

op <operation> <command>[CR]

(Precede <operation> and <command> with a space.) The command type can be one of 5 functions:

Operations Control Commands

Function	Command	Action on unit
Set	= <value>	Makes the unit take that value.
Get	?	Asks what the current value is.
Increment	+	Adds 1 to the current value.
Decrement	-	Subtracts 1 from the current value.
Execute	(none)	Performs an action such as a reset.

Table 6-2lists the valid operations commands. For all but Execute functions, the response from the projector is the command and “= <value>” where <value> is the current value or “NA” if the value is not available. For Execute functions the response is the same command. All responses are in UPPERCASE.

Some operations command examples:

Input: op bright ? [CR]
Response: OP BRIGHT = 100	[CR]
Input: op bright + [CR]
Response: OP BRIGHT = 101	[CR]
Input: op bright = 127 [CR]
Response: OP BRIGHT = 127	[CR]
Input: op bright - [CR]
Response: OP BRIGHT = 126	[CR]
Input: op resync [CR]
Response: OP RESYNC [CR]
Input: op sharp.mode = 1 [CR]
Response: OP SHARP.MODE =	1 [CR]
Input: op sharp.simple = 50 [CR]
Response: OP SHARP.SIMPLE	= NA [CR]
Input: op sharp.simple ? [CR]
Response: OP SHARP.SIMPLE	= NA [CR]

Runco LS-10i Installation/Operation Manual 79