Operation

Overscan: Some television programs are produced based on the assumption that older television sets may not display the outer edges of the broadcast picture area. Overscan effectively hides these inactive, outer edges of the image. Choose one of the following:

Off: This setting leaves the image as-is.

Crop: This setting adds a mask at the left and right edges of the source active image equal to 3% of the displayed horizontal resolution, and at the top and bottom edges equal to 3% of the displayed vertical resolution.

Zoom: This setting adds a factor to the scaling of the source active image so that the vertical and horizontal resolutions are 106% of the size determined by the aspect ratio function. Anything outside of the original image area is removed.

Figure 4-6illustrates the effect of each overscan setting for each aspect ratio.

Off

Crop

Zoom

4:3

16:9

= Source Image Area

= Edge Noise

= Screen (16:9)

Figure 4-6. Overscan Examples

Input Select: To select a video source, press or to highlight Input Select, then press

ENTER. This displays the Input Select sub-menu, shown in Figure 4-7.

The default source selection is HDMI 1. All sources that are not available per the source enable function (refer to Input Enable on page 63) are grayed out.

Runco LS-10i Installation/Operation Manual

53

Page 69
Image 69
Runco LS-10I operation manual Overscan Examples