Runco LS-10I 10. Fine Sync Sub-Menu, Runco LS-10iInstallation/Operation Manual

Operation

Fine Sync: To fine-tune the position and other image attributes, choose Fine Sync from the Advanced menu and press ENTER. This displays the Fine Sync sub-menu, shown in Figure 4-10.

Figure 4-10. Fine Sync Sub-Menu

•V Position: This control adjusts the vertical position of the image within the designated image area, up to 25 per cent of the image height up or down.

•H Position: This control adjusts the horizontal position of the image within the designated image area, up to 25 per cent of the image width left or right.

•Phase (RGB or Component sources): This control adjusts the phase of the pixel sampling clock relative to the incoming signal. Adjust the phase when an RGB or Component image still shows shimmer or “noise” after Tracking has been optimized.

Adjust the Phase after adjusting Tracking (see below). If some

Tip shimmer from a video or HDTV source persists, use the Noise Reduction controls (described on page 52) to remove high-frequency noise from the signal.

For best results, use a good test pattern such as a smooth gray consisting of a clear pattern of black and white pixels, or a similar “half on, half off” graphic image. Adjust the slidebar until the image stabilizes and each pixel is clearly defined. You may notice that you can stabilize the image at more than one point. Use either setting in such cases.

Runco LS-10i Installation/Operation Manual 59