R
INSTALLATION IN CANADA
MASONRY and HEAT-CIRCULATING
(INSTALLATIONS INTO
Whether installed in a masonry or
Chimneys and Vents, or
•Do not remove bricks or mortar from fireplace to accommodate insert.
•The face of the fireplace must be sealed to prevent room air passage into the chimney cavity.
•The permanent metal warning label provided must be affixed to the back of the fireplace with screws or nails to the fireplace, in a location readily visible should the fireplace insert by removed, stating that the fireplace may have been altered to accommodate the insert, and must be returned to original condition for use as a conven- tional fireplace.
•Circulating air chambers may not be blocked.
Leveling Bolts and sheet metal shims
This product shipped with two leveling bolts, and two sheet metal guides for ease in sliding the insert into place when using the leveling bolts. Not all installations will require the use of the leveling bolts. The sheet metal guides are used only when the leveling bolts are necessary. Discard if not
needed.
Leveling Bolt | |
|
ADJUSTING THE LEVELING BOLTS
It is best to use a 1/2 inch (12.7mm) socket wrench with an extended handle for ease in adjusting bolts to the desired level. The bolts will adjust from 0 to 2 inches (0 - 51mm). You can also reach in and adjust the bolts by hand, although space is limited. Figure 12A.
Reach between side of insert and outer skin
Figure 12A
SHEET METAL GUIDES
Slide each guide under the insert on each side placing them directly under leveling bolts. If they are not directly under the bolts, the bolts may hang up on uneven material when sliding the insert into place. See Figure 12B.
Sheet Metal Shims
Place under leveling bolts and slide insert into place
Leveling Bolts
Figure 12B
Page 12 | September 1, 2008 |
