Heat & Glo LifeStyle 36DV manual Straight Up, Flue Restrictor Instructions

STRAIGHT UP CAP

VERTICAL VENTING

V (FT.)

40' MAX. (12.4 M)

V

NOTE: On vertical venting configurations install the vertical baffle found in your manual bag per the flue restrictor instructions in this section.

Figure 8.

Straight Up Vertical Venting

Flue Restrictor Instructions

1.The flue restrictors (Figure 10) are located behind the right side panel. There is one each of the 3” diameter and 2” diameter. Use the following table to determine which restrictor to use for the vent run.

Vent Run	10’-20’	20’-40’
Vertical
NG	3”	2”
LP	3”	2”

FLUE

RESTRICTOR

FLUE RESTRICTOR

Figure 9

2.The restrictor sits inside the 5” diameter collar in the bead area. Using a needle-nose pliers, insert the tips of the pliers into the two holes in the restric- tor plate. Squeeze the pliers to flex the plate. The edges of the plate will need to overlap each other. Insert the plate into the 5” collar from inside the fire- box. Release the pliers, the plate will expand into the bead (groove) inside the collar. Make sure the plate is fully in the groove so the restrictor cannot fall out (see Figure 9).

3” & 2”

DIAMETER

Figure 10. Flue Restrictor

13