Heat & Glo LifeStyle 6100PLUS Operating Instructions, Sequence of Operation, Appliance Mode

11 Operating Instructions

A. Sequence of Operation

The 6100PLUS must be installed with an HRV200PLUS. The appliance and ventilator operate as a system. The HRV200PLUS controls many of the operational sequences for the system, and the 6100PLUS gas appliance maintains safety control for the combustion process.

The sequence of operation for the system is as follows:

Appliance Mode

•The user creates a demand for system operation using the remote control, wall switch or thermostat.

•A 12V DC signal is sent from the HI terminal on the appliance circuit board to the HRV200PLUS.

•The HRV200PLUS does the following:

-Blower motor on HIGH for system pre-purge.

-C2 terminal is energized 12VDC activating the electric ember lights on the Fresh Air Fireplace.

-Fifteen-second pre-purge timer activates while the HRV closes the alternate exhaust damper.

-C1 terminal is energized 12VDC to override pressure switch in the Fresh Air Fireplace.

•R1 is energized 12VDC activating the IPI ignition circuit to initiate the fi replace ignition process. In the HRV, the R2 terminal must be jumpered to 12V to supply power to R1 at the Fresh Air Fireplace.

•Thirty-second draft-proving delay timer activates.

•The Fresh Air Fireplace lights.

•The thirty-second draft-proving delay timer expires, C1 terminal is de-energized and the Fresh Air Fireplace

pressure switch is monitored for suffi cient fl ow at the

fl ue collar for proper operation. IF SUFFICIENT FLOW

IS NOT SENSED AT THE FLUE COLLAR OF THE FRESH AIR FIREPLACE AFTER THIRTY SECONDS OF OPERATION, THE FRESH AIR FIREPLACE FLAMES WILL EXTINGUISH LEAVING THE ELECTRIC EMBERS ILLUMINATED ONLY. THE FRESH AIR FIREPLACE WILL NOT SUSTAIN NORMAL OPERATION UNTIL THE LACK OF FLOW IS CORRECTED!

•When there is adequate draft at the flow sensor and 12VDC is present at the R1 terminal on the circuit board, the green LED on the lower left side of the board illuminates.

•When the user demand for appliance operation is removed, the HRV200PLUS de-energizes C1 and R1 terminals, terminating burner operation.

•There is a 20 second delay (post-purge).

•The HRV200PLUS de-energizes C1, turning the ember bed lights off.

•The HRV200PLUS executes a five-minute low speed post purge.

WARNING

Fire Risk

Burn Risk

HOT! DO NOT TOUCH.

SEVERE BURNS MAY RESULT.

CLOTHING IGNITION MAY RESULT

Glass and other surfaces are hot during operation and cool down.

•Keep children away.

•CAREFULLY SUPERVISE children in same room as appliance.

•Alert children and adults to hazards of high temperatures.

•Do NOT operate with protective barriers open or removed.

•Keep clothing, furniture, draperies and other combustibles away.

WARNING

Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the owner’s information manual provided with this appliance. For assistance or additional information consult a qualifi ed installer, service agency or the gas supplier.

WARNING

Do NOT use this appliance if any part has been under water. Immediately call a qualifi ed service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

24 Hearth & Home Technologies • 6100PLUS • 4041-127 Rev D • 09/05