![](/images/new-backgrounds/1054350/5435095x1.webp)
12 Electrical Information
A. Wiring Requirements | box to supply power to the unit OR install two D cell | ||
NOTICE: This appliance must be electrically wired | batteries (not included) into the battery pack before | ||
use. | |||
and grounded in accordance with local codes or, in the | NOTICE: Batteries should not be placed in the battery | ||
absence of local codes, with National Electric Code | |||
pack while using the transformer. Remove batteries | |||
ANSI/NFPA | |||
before using the transformer, and unplug the transformer | |||
Code CSA C22.1. | |||
before installing the batteries. Battery polarity must be | |||
• Wire the appliance junction box to | |||
correct or module damage will occur. | |||
required for use of optional accessories (standing pilot | |||
|
| ||
ignition) or proper operation of the appliance (IntelliFire | C. Optional Accessories Requirements | ||
ignition). | |||
• This appliance may be used with a wall switch, wall | |||
• A | |||
mounted thermostat and/or a remote control. | |||
with | |||
|
| ||
compliance with the applicable electrical codes, when | NOTE: Install optional remote receiver adjacent to battery |
| |
it is installed in locations such as in bathrooms or near | pack. See Figure 11.5. |
| |
sinks. |
|
| |
Wiring for optional Hearth & Home Technologies approved | |||
• Low voltage and 110 VAC voltage cannot be shared | |||
accessories should be done now to avoid reconstruction. | |||
within the same wall box. | Follow instructions that come with those accessories. | ||
WARNING! Risk of Shock or Explosion! DO NOT wire | Optional Remote Control Receiver and Battery Pack | ||
110V to the valve or to the appliance wall switch. Incorrect | |||
Location | |||
wiring will damage controls. | |||
Batteries are to be installed only when battery power is | |||
B. IntelliFire Ignition System Wiring | |||
required. Because of the limited accessibility to valve | |||
• Wire the appliance junction box to 110 VAC for proper | |||
cavity, the position of the Battery Tray, IPI Control Module, | |||
operation of the appliance. | and Optional Remote Control Receiver locations must be | ||
WARNING! Risk of Shock or Explosion! DO NOT wire | installed as shown in Figure 12.1. | ||
IPI controlled appliance junction box to a switched circuit. | The Battery Tray, Control Module, and Remote Control | ||
Incorrect wiring will override IPI safety lockout. | receiver can be accessed through the air space between | ||
• Refer to Figure 12.2, IntelliFire Pilot Ignition (IPI) Wiring | the fi rebox front and the | ||
The decorative front and glass assembly must be removed | |||
Diagram. | |||
to access these components. | |||
• This appliance is equipped with an IntelliFire control valve | |||
The battery tray is attached with velcro to the inside of | |||
which operates on a 3 volt system. | |||
the lower cover panel. The IPI control module and the | |||
• Plug the | |||
remote control receiver are placed on the fi rebox bottom. | |||
|
GAS VALVE
| CONTROL |
|
CONTROL MODULE GROUND | MODULE | DC ADAPTER |
| ||
|
|
BATTERY
PACK
Figure 12.1 Valve Cavity
48 | Heat & Glo • |