Heat & Glo LifeStyle SLR-B (COSMO) owner manual Heat & Glo SLR-B 2195-900 Rev. P 12/11

Non-Combustible Finish Materials

0 Inches to 4 Inches Thick Inside Fit Method

The Tonic decorative front is approved for inside fi t ap- plications. Non-combustible fi nishing materials up to 4 inches thick can be installed around the front (left, right, top, and bottom).

For the Tonic decorative front inside fi t applications, the decorative front must be installed tight to the finishing fl anges and must not overlap any fi nish material.

Ensure that minimum clearances to non-combustible fin- ish materials meet the specifi cations in Figure 13.11.

FACTORY-INSTALLED

NON-COMBUSTIBLE

BOARD

0 - 4 IN.

3/4 IN.

20-1/2 IN. APPLIANCE

OPENING (HEIGHT)

3 IN.

0 - 4 IN.

DRYWALL OR

EQUIVALENT

(1/2 IN.)

Figure 13.10 Inside Fit Method (Tonic Decorative Front Only)

Non-Combustible Finish Material 0-4 Inches Thick
3/4 IN.	3/4 IN.
	3 IN.
	Bottom Joint

Figure 13.11 Noncombustible Surface Finishing Material 0-4 Inch

Thick-Inside Fit Method (Tonic Decorative Front

Only)

Heat & Glo • SLR-B • 2195-900 Rev. P • 12/11 55