Heat & Glo LifeStyle TWILIGHT-II owner manual 5 Exterior View

NOTE: All finishing materials on top of ex- terior sheathing must be non-combustible for a minimum of 12 inches above and on both sides of the exterior face of the appli- ance. This non-combustible finishing ma- terial can be up to a maximum of 6 inches thick (6 inches maximum horizontal over- hang) to allow for brick and stone alcoves (see Figure 8.3).

NOTE: Combustible housewrap or building paper must not extend past the non-com- bustible material (12 inches above and on both sides of the exterior face of the appli- ance). Use hightemp caulk to seal between combustible sheathing housewrap and non- combustible sheathing.

Figure 8.4

STUD WALL

NON-COMBUSTIBLE

SHEATHING

SPECIAL

FLASHING

FIREPLACE

HEADER

INSULATED FRAMING

STANDOFF

SOFFIT
	31 INCH MINIMUM
SHEATHING,	CLEARANCE TO
	NON-VINYL SOFFIT,
COMBUSTIBLE
	CEILING OR OVERHANG.
HOUSEWRAP	36 INCH MINIMUM
	CLEARANCE TO
(BUILDING PAPER)
	VINYL SOFFIT,
	CEILING OR OVERHANG

12”

TOP OF

FIREPLACE

1/4” CLEARANCE

TO HOUSEWRAP

FIREPLACE

HOOD

Figure 8.5 Exterior View

HOUSEWRAP (BUILDING

PAPER) AND SHEATHING

DETAIL -

SEE FIGURE 8.3

APPLIANCE

HOOD

	SOFFIT
SIDING
		31 INCH MINIMUM CLEARANCE
		TO NON-VINYL
DRAIN PLANE		36 INCH CLEARANCE TO VINYL
		SOFFIT, OVERHANG OR CEILING
DETERMINED BY
LOCAL CODE

12 INCH MINIMUM CLEARANCE

TO NON-VINYL SIDING

36 INCH MINIMUM

CLEARANCE TO VINYL SIDING

TOP OF

APPLIANCE

BRICK OR OTHER NON-COMBUSTIBLE

FACING MATERIAL 6 INCH MAXIMUM

PROJECTION FROM SURFACE

OF FIREPLACE

NON-COMBUSTIBLE BRICK LEDGE

MUST BE TIGHT TO APPLIANCE

FACE OR NON-COMBUSTIBLE SHEATHING

20 Heat & Glo LifeStyle Collection • Twilight-II • 2087-900 Rev. G • 12/05