Heat & Glo LifeStyle TWILIGHT-II owner manual Finishing, A. Mantel Projections, B. Facing Material

8 Finishing

A. Mantel Projections

Figure 8.1 shows the minimum vertical and corresponding maximum horizontal dimensions of appliance mantels or other combustible projections above the top front edge of the appliance.

Interior	NON-COMBUSTIBLE BOARD
View
	(SUPPLIED ON APPLIANCE)
			12
		10	11
		9
		8
		7	13-5/8
		6	12-5/8
		11-5/8
		10-5/8
		9-5/8
		8-5/8
	HOOD	7-5/8
		Note: Measurements
		are in inches.
Figure 8.1	Indoor Clearances to Mantels or other
	Combustibles above Appliance

TOP VIEW

MEASURED

FROM CORNER

½ IN.

FIREPLACE

HOOD

Figure 8.2 Clearances to Combustible Mantel Leg or Wall Projections (Acceptable on both sides of opening.)

B. Facing Material

WARNING

Fire Risk.

Do NOT obstruct air inlet or outlet grilles.

Do NOT modify grilles.

•Modifying or covering grilles could cause

temperature rise and fire hazard.

Finishing materials must not interfere with:

•Air flow through grilles or louvers.

•Operation of louvers or doors.

•Access for service.

Inside Facing Material

•May install combustible materials up to specified clearances on top, front and sides of appliance.

•Seal joints between finished wall and appliance top and sides with 3000 F (1400C) minimum sealant.

•Leave space so bottom grille can be lowered for trim door removal.

18 Heat & Glo LifeStyle Collection • Twilight-II • 2087-900 Rev. G • 12/05