Heat Controller BD-123, BD-101, BDE-103, BDE-123, BD-81 manual Power Cord, Thermostat, Rotary Switch

2.3.4 POWER CORD

1.Remove the control box. (Refer to section 2.1.3)

2.Unfold the control box. (Refer to section 2.3.3)

3. Disconnect the grounding screw from the control box.

4.Disconnect 2 receptacles.

5.Remove a screw which fastens the clip cord.

6. Pull the power cord. (See Fig. 13)

7. Re-install the components by referring to the removal procedure, above.

(Use only one ground-marked hole, , for ground connection.)

8. If the supply cord of this appliance is damaged, it must be replaced with the factory-authorized and specified cord.

Figure 13

2.3.5 THERMOSTAT

1. Remove the control box. (Refer to section 2.1.3)

2. Unfold the control box. (Refer to section 2.3.3)

3. Remove the 2 screws which fasten the thermostat.

4. Disconnect all the leads of thermostat terminals.

5. Remove the thermostat. (See Fig. 14)

6. Re-install the components by referring to the removal procedures, above.

Figure 14

2.3.6 ROTARY SWITCH

1. Remove the control box. (Refer to section 2.1.3)

2. Unfold the control box. (Refer to section 2.3.3)

3. Remove 2 screws which fasten the rotary switch.

4. Disconnect all the leads of the rotary switch terminals.

5.Remove the rotary switch. (See Fig. 15)

6.Re-install the components by referring to the

removal procedure, above.

Figure 15

— 11—