Heat Controller Display, Remote Control, RAD-183A, RAD-243A, Operation, Auto Restart

Operation

2. Cooling Only Model with Remote Control and Touch Type
DISPLAY	REMOTE CONTROL
RAD-183A, RAD-243A		RAD-183A
		RAD-243A

2

7

4

3		Power
		1
8	Temp
		5
	Fan Speed
		4
1	Timer	Mode
	3	2
	Energy	Auto
	Saver	Swing

6 7

5 6

PRECAUTION: The Remote Control unit will not

function properly if bright light strikes the sensor window of the air conditioner or if there are obstacles between the Remote Control unit and the air conditioner.

POWER BUTTON

Operation starts, when this button is pressed and stops when you press the button again.

OPERATION MODE SELECTION BUTTON

Select Cooling, or Fan or Dehumid mode with button. (Dehumid mode is not to all models.)

ON/OFF TIMER BUTTON

Set the time of starting and stopping operation. The timer is set by 1 hour.

FAN SPEED SELECTOR

Select the fan speed in three steps.

- High [F3] ➔ Low[F1] ➔ Med[F2] ➔ High[F3]... .

ROOM TEMPERATURE SETTING BUTTON

Control the room temperature within a range of 60°F to 86°F by 1°F.

6ENERGY SAVER(Available In some models)

The fan stops when the compressor stops cooling.

Approximately every 3 minutes the fan will turn on and check the room air to determine if cooling is needed.

7AUTO SWING BUTTON

Control the horizontal air direcion by air swing system.

AUTO RESTART

In case the power comes on again after a power failure, the unit runs as previous setting operation.

Service Manual 14