Heat Controller RAH-123G Room Air Heat Pump with R-410A, Heat Controller, Inc, Back View

Owner’s Manual Room Air Heat Pump with R-410A Heat Controller, Inc.

Attach Side Curtains

1.Locate provided bag of screws.

2.Insert top and then bottom of right-hand curtain housing in top and bottom curtain guides on air conditioner cabinet.

Back View

AB

A. Curtain housing

B. Curtain guides

Bottom View

A

B

A. Curtain housing

B. Curtain guides

3.Extend right-hand curtain outward so you may insert the first screw through the middle hole of the curtain. Using #10 x ¹⁄₄" pan-head Phillips screw, screw curtain to middle hole in air conditioner cabinet.

NOTE: This screw is required to correctly attach curtain (top to bottom) to the air conditioner cabinet.

4.While the right-hand curtain is still extended, insert

#10 x ¹⁄₄" pan-head Phillips screws into the top and bottom slots of curtain. Screw curtain to the top and bottom holes in air conditioner cabinet.

NOTE: Some curtains may have 2 slots at each end. You will be able to see a mounting hole through the correct slot.

5.Slide curtain housing into guides as far as it will go.

6.Repeat above steps for left-hand curtain.

Attach foam adhesive seal

Attach foam adhesive seal along the bottom of the curtain bottom channel.

A

B

A. Curtain housing

B. Foam adhesive seal

Install Cabinet into Window

■Handle air conditioner gently.

■Be sure your air conditioner cabinet does not fall out of the opening during installation or removal.

■The location where the power cord exits the air conditioner should be no more than 4 ft from a grounded 3 prong outlet.

■Do not block the louvers on the front panel.

■Do not block the louvers on the outside of the air conditioner.

1.Center empty cabinet in window. Check that lower rail of air conditioner cabinet is behind and against back side of windowsill. Maintain a firm hold on the air conditioner cabinet. Lower window sash to hold cabinet in place.

Top channel must be on inside room of window sash.

Windower sash Top channell

2.Measure the distance between the right-hand side of the cabinet and the inside of the window channel.

3.Repeat for the left side. Adjust the cabinet until the distance on each side is the same.

A

B

C

A. Window sash

B. Empty cabinet

C. Window channel

9