Heat Controller RAH-123G Heat Controller, Inc, Room Air Heat Pump with R-410A, Fan Motor Care

Heat Controller, Inc.	Room Air Heat Pump with R-410A			Owner’s Manual
		if	Air Filter Cleaning
Note:Thelifeofyourunit may be greatly reduced ifyou live
and/or oceanside location with salty air. Under			A dirty air filter reduces operating efficiency of unit. Filter
in asaltcorrosiveair other corrosive type environment. Under these
these conditions, the unit should be	removed from it c se		should be inspected at least once every week during opera-
conditions, the unit should be removed from its case and
and completely cleaned at least once	.	At that time any	tion. Clean filter with vacuum cleaner or wash in warm water
completely cleaned at least once a year.
or blisters on the painted surfaces should be sanded			and mild detergent. Filter should be thoroughly dried before
scratches or blisters on the painted surfaces should be
repainted. Placing an algaecide tablet in the outdoor side			replacing in unit. do not operate unit without filter in place.
sanded and repainted. Placing an algaecide tablet in the
of the unit’s basepan is suggested in humid areas where algae
outdoor side of the unit’s basepan is suggested in humid
formation is common.			Fan Motor Care
areas where algae formation is common.
			The fan motor is permanently lubricated for long life. There is
			no need to oil the motor.
Front Grille and Filter Removal			Slide-out Chassis Removal from Outer Case
The front contains an air filter that can be removed on left or
			4. If the unit has a screw holding the basepan clip to the
right side of front. To clean the filter use one of the following
			chassis, remove the screw.
methods for filter removal:
METHOD ONE			CAUTION
			To reduce the risk of personal injury, be
Grasp filter handle and slide filter out of unit.
			sure to have sufficient help when moving
			your unit. Check the weight of your unit by
			contacting your dealer.
			5. Using basepan handle, pull chassis straight out, slowly
			and evenly, until approximately 9-12 inches extends
+			from outer case. Use both hands to grasp basepan and
-
			pull remaining chassis from outer case.

1.Remove two side ground screws attaching case to chassis basepan.

2.Remove two control knobs.

3.Remove two side Phillips screws attaching front panel to case.

+ -

CHASSIS	BASEPAN	PLASTIC
	CLIP	FRONT

NOTE: Basepan clip is shipped in plastic bag with mounting screw and condensate drain cup. Install clip after reinserting chassis into outer case to prevent accidental chassis removal.

Reinstall air filter by reversing removal procedure.

Front Grille and Cabinet Cleaning

Grille and cabinet may be cleaned with warm water and mild soap or detergent. Cleaning and polishing compounds are not recommended, as they may damage plastic surfaces.

4