Heat Controller RAH-123G owner manual Installation Instructions, Unpacking, Heat Controller, Inc

Models: RAH-123G

1 16
Download 16 pages 27.17 Kb
Page 9
Image 9
INSTALLATION INSTRUCTIONS

Heat Controller, Inc.

Room Air Heat Pump with R-410A

Owner’s Manual

 

 

 

INSTALLATION INSTRUCTIONS

Unpacking

UnpackingWARNING

Excessive Weight Hazard

Use two or more people to move and install air conditioner.

Failure to do so can result in back or other injury.

3.Remove front panel by removed 2 phillips screws on both bottom left right sides of front.

3A: Remove both knobs from control panel.

4. Pull on handle to slide air conditioner out of cabinet. Place air conditioner on cardboard.

5. Remove any paking foam from inside of unit.

Remove packaging materials

Remove and dispose of/recycle all packaging materials. Remove tape and glue residue from surfaces before turning on the air conditioner. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.

Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your air conditioner.

Handle air conditioner gently.

1.Remove air conditioner from carton and place it on cardboard.

2.Remove shipping screws from both sides of cabinet.

A

A. Shipping screw

Excessive Weight HazardA

A. Handle

NOTE: Do not lift, push, pull or remove any expanded polystyrene (foam) from inside the air conditioner. It is not packing material.

NOTES:

WindowWindowInstallationInstallation(on some models)

3. Using 3 - #10 x ³⁄₈" pan-head Phillips screws, attach top

Handle air conditioner gently.

channel to air conditioner cabinet.

 

Be sure your air conditioner cabinet does not fall out of the

 

opening during installation or removal.

B

A

B

B

The location where the power cord exits the air conditioner

 

 

 

 

 

should be no more than 4 ft from a grounded 3 prong outlet.

 

 

 

 

Do not block the louvers on the front panel.

 

 

 

 

Do not block the louvers on the outside of the air conditioner.

 

 

 

 

Attach Top Channel

NOTE: Attach top channel and side curtains to air conditioner cabinet before placing cabinet in window.

1.Locate supplied bag of screws.

2.Place top channel on top of air conditioner cabinet, lining up the 3 holes in top channel with the 3 holes on top of air conditioner cabinet.

A. Top channel

B. #10 x ³⁄₈" pan-head Phillips screws (3)

8

Page 9
Image 9
Heat Controller RAH-123G Installation Instructions, Unpacking, Heat Controller, Inc, Room Air Heat Pump with R-410A