Keyhole |
1 9/16" |
Holes |
for Wall |
Mounting |
Case Style “A” Back
Attach back of case to door jamb or wall. Snap front of push button on.
When attaching push button using double sided tape, make sure the surface of the door jamb or wall is clean.
Case Style “A”: Chime can be mounted by using 2 holes in the back of case, or by using 1 screw with keyhole.
Case Style “B”: Chime can be mounted by using 1 screw with keyhole (see illustration on page 1).
Case Style “A”: Snap front of chime case on. Start with top edge of case aligned with the top of back plate.
Case Style “B”: Snap battery access door firmly in place before mounting (See illustration on page 1).
Code and Tune Settings
Code Settings
Note: Most installations will not require you to change any jumpers on your chime and push button.
The push button and chime communicate by using a code that can be changed by removing and/or adding jumpers on both the push button and chime. The code is factory set; however, there are 128 selectable codes that allow you to expand your system and prevent outside interference. Other wireless products may cause interference and the system may not function properly. Follow the instructions below for setting a new code.
1.Open the cases and locate the jumpers on both the push button and chime (See illustration on page 3).
2.The push button and chime both have eight different jumper locations. The jumper positions 1 through 7 are used for setting the code.
3.To change the code, add and/or remove jumpers as needed. It is recom- mended to only change one jumper at a time and then check to see if system is functioning properly. Note: Jumpers in positions 1 through 7 must be exactly the same for both the push button and chime for this system to function.
- - |
