Heath Zenith 595-5578-09 manual Specifications, Troubleshooting Guide

SPECIFICATIONS

Range	Up to 30 ft. (9.1 m)
	[varieswithsurrounding
	temperature]
Sensing Angle. . .	Up to 150°
Electrical Load. . .	See rating on fixture
	for maximum wattage
Sensor Capacity . .	Upto360Watts(3.0A.)
	Maximum Tungsten
	Incandescent
Power Requirements 120 VAC, 60 Hz
Operating Modes. .	TEST, AUTO, and
	MANUAL MODE
Time Delay . . . .	1, 5, 10 minutes
DualBrite® Timer. .	Off, 3, 6 hours, dusk-to
	dawn

HeathCo LLC reserves the right to discontinue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.

TROUBLESHOOTING GUIDE

SYMPTOM	POSSIBLE CAUSE
Light will not	1.	Light switch is turned off.
come on.	2. Bulb is loose or burned out.
	3.	Fuse is blown or circuit breaker
		is turned off.
	4.	Daylight turn-off is in effect
		(recheck after dark).
	5.	Incorrect circuit wiring, if this
		is a new installation.
	6.	Re-aim the sensor to cover
		desired area.
Light comes on	1. Light control may be installed
in daylight.		in a relatively dark location.
	2.	Light control is in Test. (Set
		control switch to an ON-TIME
		position.)
Light comes on	1. Light control may be sensing
for no apparent		small animals or automobile
reason.		traffic (re-aim sensor).
	2.	Sensitivity is set too high.
		(Reduce sensitivity.)

SYMPTOM	POSSIBLE CAUSE
Light stays on	1. The sensor is pointed toward
continuously.		a heat source like an air vent,
		dryer vent, or brightly-painted
		heat-reflective surface.(Re-aim
		sensor.)
	2.	Light control is in Manual Mode.
		(Switch to Auto.)
	3.	Light control is in DualBrite®
		mode.
	4.	Sensitivity is set too high. (Re-
		duce sensitivity.)
Light flashes	1. Heat being reflected from other
on and off.		objects may be affecting the
		sensor. (Re-aim sensor.)

595-5578-09