❒ Walk through the coverage area noting |
where you are when the lights turn on. |
Move the sensor head left or right to |
change the coverage area. |
BULB REPLACEMENT
If lantern has an open bottom, insert bulb through opening and screw into socket.
IMPORTANT: Grasp the sensor only as shown and turn the entire sensor. Any other method may damage the sensor. Do not force the sensor past the stop-
If lantern has a closed bottom, follow the steps below to replace bulb.
1.Place one hand under lower glass assembly and un- screw decorative screws holding lower glass as- sembly to top of fixture.
2.Replace bulb.
3.Reattach lower glass assembly to fixture top us- ing decorative screws.
Decorative Screws
Light 
Bulb
Lower Glass
Assembly
ping points.
|
| ° | 1 |
| 0 | 5 | |
| 5 |
| |
|
| ° | |
1 |
|
| 0 |
|
|
| |
Rotating Sensor Head to Change
Coverage Area
❒If you need to change the sensitivity, temporarily remove the fixture and make the adjustment. Too much sensitivity may increase false triggering.
❒Set the amount of TIME you want the light to stay on after motion is detected. (1, 5, or 10 minutes).
❒Set the amount of time after dusk you want the lights on accent level.
SPECIFICATIONS
Range | Up to 30 ft. (9.1 m) [varies with | ||
|
| surrounding temperature]. | |
Sensing Angle | Up to 150° | ||
Electrical Load | Up to 100 Watt Maximum | ||
|
| Tungsten Incandescent | |
Sensor Capacity | Up to 360 Watt (3.0 A.) | ||
|
|
| Maximum Tungsten |
|
|
| Incandescent |
Power Requirements | .......... 120 VAC, 60 Hz | ||
Operating Modes | TEST, AUTO, and | ||
|
|
| MANUAL MODE |
Time Delay |
| 1, 5, 10 minutes | |
DualBrite® timer | Off, 3, 6 hrs, | ||
|
|
| |
6 |
