HHB comm CDR 830 Display messages relating to recording, Cant, Sync, Unlock, Input?, Set Up

7 Additional information

Display messages relating to recording

Note: In the table below, ** indicates a track number.

Display	Cause	Remedy
Can't	This appears when the	Record the source manually, or record through the
SYNC	SYNCHRO button is pressed	analog input.
	when the input selector is set
	to a digital input, and the
	source selected is not
	recognized as CD, MD, DCC,
	or DAT.
DIN	The digital source was	Check that the digital input cable is connected properly
UNLOCK	interrupted.	and that the power of the source player is on.
	The source is not audio, or is	Check that the source is a regular music source.
	an incompatible format (e.g.
	a CD-ROM).
CHECK	The source player was	Stop the source player. After a short time, SYNC–1 or
INPUT?	already playing when the	SYNC–ALL is displayed, and the recorder goes into
	SYNCHRO button was	synchro–record-pause mode.
	pressed.
** SET UP	The unit is preparing to	Wait until the message disappears.
	record.
REPAIR	The recorder was switched	While REPAIR is displayed, the recorder automatically
	off/unplugged after	examines the recorded area of the disc and updates the
	recording without ejecting	track numbers and recording time data. This process
	the disc. The recorder could	takes about 40 minutes for a fully recorded disc.
	not write essential recording	Finalization or further recording is possible once the
	information onto the disc.	REPAIR message disappears.
REC FULL	No more recording is	Use another disc, or erase the CD-RW disc.
	possible because the
	available recording time of
	the disc has been used up, or
	99 tracks have already been
	recorded on the disc.

If digital synchro-recording fails to operate correctly, check the following:

1.Pause playback of the source, then press the DIGITAL SYNCHRO button again.

•If you’re recording from a portable CD player, etc., make sure that the shock-protection feature is switched off.

2.Start playback of the source component once you see the SYNCHRO indicator start to blink.

3.If none of the above solves the problem, use manual digital recording to record.

•Digital synchro-recording uses a digital sub-signal contained in the source player’s digital output. Digital synchro-recording will not work when recording from the following devices:

•CD players whose digital output does not include a sub-signal

•Portable CD, MD or DVD players which do not output a digital signal when stopped.

41