HHB comm CDR 830 Power cannot be, Turned on, No sound is heard, During playback, Cannot record

It’s often easy to mistake incorrect operation for trouble and malfunction of the unit. If you think there is something wrong with the component, check the points below first. If the problem persists, contact you nearest HHB authorized service center and have them check over the unit.

Symptom	Cause	Remedy
Power cannot be	The power cord is unplugged from the wall	Plug the power cord into a
turned on.	outlet.	power outlet.
	The power plug is not firmly connected to	Make sure that the power plug is
	the recorder.	fully inserted in the recorder.
No sound is heard	The recorder is not connected up properly.	Check all connections, especially
during playback.		to the amplifier (p.10–11).
Cannot record.	The recorder is not connected up properly.	Check all connections (p.10–11)
	The CD-R or CD-RW disc in use has already	Use a non-finalized disc or erase
	been finalized.	the CD-RW disc (p.38).
	The input selection is incorrect.	Select the input for the correct
		input source to the recorder.
	The REC LEVEL control is set too low.	Increase the recording level
		(p.23–24).
Recorded sound is	The REC LEVEL control is set too high.	Reduce the recording level (p.23
distorted.		–24).
	Signal connections are incorrect.	Check all connections (p.10–11)
	There is interference from external	Turn the power off to other units
	sources.	near the recorder until there is no
		interference.
	The disc is damaged or warped.	Use another disc.
	The disc is extremely dirty.	Clean the disc.
Remote control	The remote control batteries are	Replace both of the remote
operation is	exhausted.	control batteries with new ones.
impossible.	There is an obstacle between the remote	Remove the obstacle.
	control unit and main unit.
	The remote control unit is being operated	Operate in the remote
	outside the remote controllable range.	controllable range (p.9).
Some tracks are	The SKIP PLAY button is set to on.	Set the SKIP PLAY button to off
skipped without		(p.28).
being played.
Skip playback does	The SKIP PLAY button is set to off.	Set the SKIP PLAY button to on
not occur.		(p.28).
The recorder does	The level that the recorder regards as	Set the silence threshold to a
not recognize the	‘silence’ is set either too low, or too high.	suitable level for automatically
end of tracks		numbering tracks (p.33).
during sync
recording.

42

A recorded CD-R disc cannot be played on other CD players.

The disc has not been finalized after recording. When such a disc is loaded, the CD-R indicator lights up.

The pickup lens of the other CD player is dirty, impairing its ability to play CD-R discs.

Finalize the disc (p.26).

Try the disc on a different CD player. If it plays OK then get the pickup lens on the original player cleaned.