www.hi-ti.com }}
30
CARD OUT SNR The sensor for cards in the
card-insert mechanism. (ENABLE /
DISABLE) The default setting is
[DISABLE]. However, once you
switch [DISABLE] to [ENABLE] and
there are no cards in the Card Input
Hopper, the error message [CARD
OUT] will be shown on the LCD
display. If the [Card Out] message
continues to exist, even after you
have inserted cards into the Card
Input Hopper and restart your
computer, then please switch
[ENABLE] to [DISABLE] and refer to
Chapter 5 Troubleshootin “The
Error Message shown on the
Computer Monitor and the
Solutions”→ “Card out or feeding
error” OR “The Error Message
shown on the LCD Display and the
Solutions” → ”CARD OUT”. After
above procedures if this error
message still persists, please contact
the HiTi customer service center.
ADF SENSOR SEL The sensors for card (ADF SENSOR
1/ADF SENSOR 2). When the card
feeding process fails, you can try to
switch ADF SENSOR 1 or ADF
SENSOR 2 for troubleshooting. If the
problem can not be resolved, please
refer to Chapter 5 Troubleshootin
“The Error Message shown on the
Computer Monitor and the
Solutions”→ “Card out or feeding
error” OR “The Error Message
shown on the LCD Display and the
Solutions” → ”CARD OUT”. After
above procedures fail and if the card
feeding process still fails, please
contact the HiTi customer service
center.
CLEANING MODE PUT CLEANING KIT &
OPEN THE DOOR &
CLEAN PROCESSING
Please follow the instruction on the
LCD Display. Remove the peel-off
film from the cleaning card. Insert the
cleaning card and open the ribbon
door. Press [OK] button to initiate the
cleaning process.