Hitachi 28LD5000TA user manual Size Switching, Input Signal Screen Display

RECALL button

i +	I / II
MENU	A / B	2-4-12
	P+
-	OK	+
	P-
D VD
		FREEZE
		ZOOM

ZOOM button

Size Switching

Each time the ZOOM button of the remote control is pressed, the screen display area will change in sequence and the status will be displayed at the bottom of the screen.

Normal Full Zoom1

Real* Zoom3 Zoom2

Display area selection diagram (RGB input)

Processes such as compression (thinning) and expansion are performed for the above signal display. Because of this, there is a possibility that flicker may become noticeable on Zoom (1 ~ 3) depending on the display contents. If this occurs, turning the Vertical Filter On 21 can reduce the flicker.

Input Signal Screen Display

The input signal status can be displayed on the screen by pressing the RECALL button of the remote control.

•The display will go out in approximately 6 seconds.

RGB

Off-timer On-timer

					Input mode
				RGB2
				RGB	Signal mode
		H :	48.4kHz
					Input horizontal frequency
		V :	60.1 Hz
					Input vertical frequency
OFF	-- -- Min.
ON	-- -- : -- --

16