Hitachi 28LD5000TA user manual Operating Instructions, Turning Power On and Off, Indicating lamp

23 25

OPERATING INSTRUCTIONS

Indicating lamp

Main power switch

(28")

SUB-POWER button

POWER ON/OFF D / N

button

i +	I / II
MENU	A /B	2-4-12

P+

-+

OK

P-

D VD

FREEZE

ZOOM

1 2 3

4 5 6

7 8 9

0

AV1	AV2	AV3	AV4
		RGB1	RGB2

Turning Power On and Off

•To turn the monitor power ON, press the main power switch on the monitor main unit to ON, and then press the SUB POWER button or the ON/OFF or ON button on the remote control.

•To turn the monitor power OFF, press the SUB POWER button or the ON/OFF or OFF button on the remote control, and then press the main power switch on the monitor main unit to OFF.

•During normal use, the main power switch is set in the ON position, and the monitor can then be turned ON/OFF using the SUB POWER button or the ON/OFF button on the remote control.

Indicating lamp

Indicating	Power status	Operating
lamp
Off	Off	When the main power switch is set
		to OFF.
		When the main power switch is
	Off	ON, and the OFF button on the
Lights red		remote control or the SUB POWER
	(standby)
		button on the top of the front of the
		frame is OFF.
		When the main power switch is
		ON, and the ON button on the
Lights green	On	remote control or the SUB POWER
		button on the top of the front of the
		frame is ON.
		When the main power switch is
		ON, and the ON button on the
	Off	remote control or the SUB POWER
Lights orange		button on the top of the front of the
	(Power Save)
		frame is ON.
		However, the state in POWER
		SAVE mode

When the indicating lamp lights in orange or the message “No Sync. Signal”, “Power Save” or “Invalid Scan Freq.” appears on the screen, there is something unusual about the status of reception. See “Power Save Mode” or “Symptoms That Seemingly Appear to be Failures.”

ATTENTION

•Avoid repeatedly turning the monitor on and off at short time intervals. Failures might result from such operation.

•Turn off the main power switch before leaving the monitor out of use for an extended period of time.

•If a power failure occurs while the main unit is running, it would be powered on upon recovery from the failure. Turn off the unit main power switch before leaving the main unit.

14