DTS Error Codes
No display does not mean that sprayer is not pressurized. Relieve pressure before repair; page 4.
DISPLAY | SPRAYER | INDICATION | ACTION |
| OPERATION |
|
|
|
|
|
|
| Engine runs. Pump stops. | Pressure exceeded | Correct |
|
| 4900 psi (338 bar, 34 MPa) | Check transducer and control |
|
|
| board. Take to service center. |
|
|
|
|
| Engines runs. Pump operates. No | Pressure transducer faulty, | Check transducer connection. |
| pressure displays. | bad connection or broken | Open drain valve. Substitute |
|
| wire. | new transducer for transducer |
|
|
| in sprayer. If sprayer runs, re- |
|
|
| place transducer. |
|
|
|
|
| Engine runs. AutoClean timer cancels. | Pressure exceeded | Turn directional valve OFF |
|
| 2000 psi (338 bar, 34 MPa) |
|
(AutoClean) |
| while in AutoClean. |
|
|
|
|
|
| Engine runs. Setup is exited. | Pressure exceeded | Turn directional valve OFF, |
(Setup) |
| 500 psi (34 bar, 3.4 MPa) | then ON. |
| while in Setup. |
| |
|
|
|
|
| Engine runs. Pump switch OFF | Normal condition | Turn pump switch ON. |
|
|
| Increase pressure. |
|
|
|
|
After a fault, follow these steps to restart sprayer:
1.Correct fault condition
2.Turn pump switch OFF
3.Turn pump switch ON
