AV NETWORK SETUP WIZARD
SETUP PROCEDURE USING AV NETWORK DEVICE CODES:
A DVD Setup example is shown below. Setup of DVD2, VCR, VCR2, PV Recorder, Cable Box and
FIRST TIME USE
1.Press the A/V Net button on the remote control.
2. | Use CURSOR PADS and to highlight Device Setup. |
3. | Press the SELECT button or CURSOR PAD on the |
| remote control and the device selection screen appears. |
4. Use the CURSOR PADS and to choose DVD and press the SELECT button on the remote control.
5.The Setup button on the bottom of the screen becomes highlighted. Press the SELECT button on the remote control to enter the setup screen.
6.Using the remote, enter the four digit Device Code for your equipment, found on page 26.
7. | Use the CURSOR PAD | to select Video Input. Press the |
| CURSOR PADS | and to set the INPUT to which |
your | device is connected. | |
8.Repeat step 7 for Audio Input. If the DVD is connected to the TV, select “Using TV”. If the DVD is connected to an external
amplifier, select “no connection”.
9. Press CURSOR PAD | to select Transmission Test. Press |
the CURSOR PADS | , to select Power, Play, or CH UP |
softkeys, before pressing the SELECT button to perform a Transmission Test of the softkey selected. If the device responds, then it is properly set up. Select OK. (If the Transmission Test failed, try another code.)
10.If “OK” was selected, and the 4 digit code was invalid, the screen below appears, then goes back to the Device
Code | entry screen. |
11.Repeat Device Setup procedure until the screen below appears.
12.Select CONTINUE to setup another device.
13.Select DONE to finish and the screen below appears to show the device(s) which has been
14. Select EXIT to quit.
24
