Hitachi 37HLX99 important safety instructions Upgrade Card, Power Swivel Connector, CableCARD Slot

Rear Panel Connections

￿Upgrade Card

This card slot is for future software upgrades. Hitachi will notify you if a software upgrade is required for your TV. In order to receive written notification, please complete and return your warranty card.

￿Power Swivel Connector

Connects to the Power Swivel Table Top Stand.

￿CableCARD Slot

This slot is for the CableCARD that will be provided by your local cable operator to gain access to chosen cable channels. The CableCARD will allow you to tune digital and high definition cable channels. Please call your local cable operator if this service is available before requesting a CableCARD (also known as Point of Deployment (POD) module).

1.Connect a coaxial cable to cable terminal of the Rear Panel Jacks.

2.Insert the CableCARD into the slot (Top of card should be facing towards you as shown below). Completely insert the card until the back end aligns with the line as shown.

Digital Cable

INSERT

NOTE: 1. A digital cable subscription is required.

2.Do not insert a PCMCIA card into the CableCARD slot.

If the CableCARD is properly installed or removed, the TV will display the following respective screens.

CableCARD is installed

OR

CableCARD is not installed

After the CableCARD is installed, wait until the second screen below appears.

Acquiring Data.

Please wait.

In order to start cable service for this device, please contact your cable provider

CableCARD(tm): 123-456-789-1

Host: 123-456-789-1

Data: 123-456-789-1

Unit Address: 123-456-789-1

Press EXIT to return

Please take note of all information on the screen (you will provide this information to your cable operator). Call your cable operator and give them the information

from the card to start your cable service (refer to page 67 for more information).

First time use

13