The Remote Control for Additional Audio Equipment
Operating the precoded function for your Audio component.
This remote is designed to operate different types of Audio component. You must first program the remote to match the remote system of your Audio component
(refer to pages
1.Turn ON your Audio component you wish to control with the Remote.
2.Aim the remote control at the front of your Audio component.
3.To switch to Audio (AMP) component
mode, use the SOURCE ACCESS buttons ( or ) on the remote control to position the LED light to the corresponding selection.
4. Hold down the ENT button on the remote and enter |
the four digit preset code that matches your Audio |
component, as shown on pages |
the ENT button. The indicator light will flash 3 |
times if the code was accepted. |
+
-
The Remote
5. | Aim the remote at the Audio component and press |
| the POWERbutton. The remote will turn off your |
| Audio component when the correct four digit |
| preset code is entered. When this occurs, the |
| remote control is programmed for your Audio |
| component. If the Audio component does not turn |
| off, try a different four digit preset code. |
6. | The remote will now control your Audio |
| component. |
7. | Repeat steps 1 - 6 if you wish to program the |
| remote to control another Audio component. |
NOTE: 1. If your Audio component cannot be operated after performing the above procedures, your Audio component code has not been precoded into the remote.
2. | In the unlikely event that your Audio |
| component cannot be operated after |
| performing the above procedures, please |
| consult your Audio component operating |
| guide. |
3. | The remote control will remember the |
/
MY AUDIO COMPONENT CODE IS:
Control
codes you have programmed until the |
batteries are removed from the |
remote control. After replacing the |
batteries repeat the entire programming |
procedure as stated above. |
PRECODED AUDIO Buttons |
These buttons transmit the chosen precoded Audio |
component codes. |
EXCLUSIVE TV Buttons |
These buttons are for operating the TV. |
NOTE: Refer to instruction manual of the VCR/PVR for operation of the buttons exclusively for the VCR/PVR.
37
