SOAK Process
浸洗程序
Wash with special moving steeped water flow
運用特設的運動浸泡水流進行洗衣
Put the laundry in and press the "POWER
SWITCH" button 
.
放入衣物，按下電源開關按鈕
Press the "PROGRAM" button 
and select the "SOAK" process.
按下『程序』按鈕 
，選擇『浸洗』程序
With each pressing on the "PROGRAM" button, the indicator will light or flash in sequence.
每按動一次『程序』按鈕，各指示燈會順次點亮或 閃動。
Press the "start" button 
.
按下『動』按鈕 
★Put in the detergent according to the amount and close the lid.
(The sound of buzzer indicates washing completion)
根據顯示的水位，
放入洗衣粉，關閉機蓋
（蜂鳴聲響起表示洗衣完畢）
•The pulsator to detect the amount of laundry and display on the
control panel. 
19
攪拌翼旋轉檢測出洗衣量並由控制面板顯示出來。 
19
•After the detergent amount and the water level are displayed, the washing machine will pause about 1 minute for putting in the detergent.
(Press the "WATER LEVEL" button, and the washing machine starts operation)
顯示出洗衣粉量和水位後，洗衣機會為投放洗衣粉而等待 1 分 鐘左右。
（此時按下『水位』按鈕，則洗衣機會立即開始運轉）
•After the lid is closed, the washing machine will detect at the low water level and the required water level in order to dissolve the detergent and know about the quality of laundry, then it will decide the necessary mode of washing.
關閉機蓋後，為溶解洗衣粉並瞭解衣物質地，洗衣機會在低水 位和規定水位處進行檢測，然後決定所需的洗衣方式。
Use of detergent ： Powder synthetic detergent
使用洗衣粉 粉末合成洗衣粉
：Liquid detergent
液體洗衣劑
•How to put detergent in 
20~21
關於洗衣粉的投入方法 
20~21
During soaking, the "WASH" LED flashes in turn to show that it is soaking.
在浸洗過程中，“洗衣”指示燈會依次序循環閃動，以告知您 正在進行浸洗運轉。
29
