Hitachi AJ-S55GZ Content of the washing process

42

Content of the washing process

This part describes the process of each process.

( ) indicates it may be manually switched within the range contained in the bracket by pressing

the buttons. No ( ) means no switch.

( ) ( )

(Water-storage or water-injection rinsing 1~3 times)

1

~

3

(Water-storage or water-injection rinsing 1~3 times)

1

~

3

15

(15~3 )

50~20L

(50~20L)

3~6

(9~1 )

46

(60~28 )

Process

NORMAL

Washing Spinning

Required duration

(approximate)

Rinsing

Round 1

Sprinking rinsing Water-storage +

water-injection rinsing

(Water-storage or water-injection rinsing 1~3 times)

1

~

3

no rinsing

(Water-storage or water-injection rinsing 1~3 times)

1

~

3

Water-storage rinsing Water-storage rinsing

Round 2

Automatic setup

of water level

30

(30~3 )

50~20L

(50~20L)

3

(15~3 )

20L

(30~20L)

60

50~20L

(50~20L)

9

30L

(30~20L)

25

50L

(50~20L)

63

(76~28 )

6

(9~1 )

12

(45~20 )

3

(9~1 )

100

(112~75 )

6

(9~1 )

36

1

68

(68~59 )

9

(9~1 )

HEAVY

SPEEDY

SOAK

SILK

BLANKET

Water-storage rinsing Water-storage rinsing

Water-storage rinsing Water-storage rinsing

Water-storage rinsing Water-storage rinsing

15

(15~3 )

50~20L

(50~20L)

103

(112~85 )

60

WIND

DEHYDRATION

(Water-storage or water-injection rinsing 1~3 times)

1

~

3

Water-storage rinsing Water-storage rinsing

Time required for washing

•The washing time includes the time of charging (volume of

15L per minute) and draining (standard condition).

15L

•The washing time depends on the water pressure, washing

quantity and drainage condition etc.

•In the "NORMAL", "HEAVY", "SOAK" and "WIND DEHYDRA-

TION" processes, the washing machine determine the opti-

mum washing mode by checking the load and texture of the

washings. The time shown in the above table are ones in

standard condition.(marked with ).

•There are certain errors between the "washing time" & "spin-

ning time" and the actual operation time.

•The "NORMAL", "HEAVY", "SOAK" and " WIND DEHYDRA-

TION" processes, the washing machine will stir the clothes for

after final spinning for fluey effect. (stirring may not be made

for some washing loads.)

Change of the options in the modes

•( ) indicates it may be manually switched within the range

contained in the bracket by pressing the buttons.

( )

•Options in modes can't be changed after the completion of the

"washing" process.

• Changes can't be made during the period from the beginning

of charging to the time when the level of charged water reach

the stated standard.

Switch of modes

•Modes can't be switched after the starting of washing machine.

If it is necessary to switch, please cut off the power supply

first, and then proceed with the switch.



Contents

Main CONTENTS Preface Air-jet drying 2,3,4 Loosen the post-spinning laundry for easy taking out. Infiltration washing Safety Precautions Graphic mark Warning ~ Attention Page Safety Precautions (continued) Warning Attention Installation Guide Installation of Washing Machine ( ) Installation Guide (continued) 1 Installation of Washing Machine 1 Inspection of trial run How to Use the Adjustable Leg How to Change the Water Drainage Hose and How to Install the Base Plate Attention 2 Installation Guide (continued) Water Drainage Hose Related Parts Connecting the water supply hose to the main unit Extended the water supply hose How to Install the Water Supply Hose Attention 1 34Tighten joint B in the arrow direction Appropriate water tap How to install and remove the water supply hose Water tap Installation Attention Attention Main unit Safety Check In case when the washing machine is used in places other than ordinary households. Washing Machine Repair Page Page Lid Lock function Hope to switch off the buzzer beep after the completion of the washing process 3 Setup safe model 1 2 beep can be switched off. 1 2 3 Control Panel (continued) When you want to open the lid Technical Description The number next to the sign is the page number for detailed description. Accessories (Refer to Installation Guide ) ( ) Before Using Your Machine Preparation for washing machine Preparation for laundry When the first using Daily using Checking amount of laundry and detergent (Approximately amount) How to put laundry in Amount of detergent (Approximately amount) Checking amount of laundry How to Use Liquid Detergent, Bleach and Fabric Softener 2 3 1 Insert the pin into the pin hole at the injection opening. Put the detergent in the detergent dispenser Liquid detergent/Bleach / Fabric softener Notes Open the cap of the fabric softener injection opening. Close the cap of the fabric softener injection opening. Amount of Laundry and Detergent NORMAL WIND DEHYDRATION Selection of Laundry Process Recommended Automatic Process Type of laundry Recommended Detergent Do not use detergent dispenser in SILK and BLANKET process. NORMAL Process Washing of the "NORMAL" process Sufficient wash with economic consumption of water, electricity and time HEAVY Process Washing of the HEAVY process Through wash SPEEDY Process Washing of the "SPEEDY" process SOAK Process SOAK Process (continued) Washing of the "SOAK" process SILK Process Washing clothes with "Dry clean" label Before using your machine SILK Process (continued) Preparation for the washing Make sure the decoloring possibility Preparation for the laundry Use of detergent How to wash After washing SILK Process (continued) Washing of the "SILK" process BLANKET Process Before using your machine 12 How to put in comforter and blanket BLANKET Process (continued) How to wash Washing of the "BLANKET" process Method to take out After the end of washing Natural air-jet at the place with good ventilation Using the Washing Cap Installation of the washing cap 1 Adjustment of the position and height of the washing cap Taking out the washing cap 12 1 Attention Page How to use the "WATER LEVEL" button How to use the "WASH" button 9 15 How to use the "RINSE" button Content of the washing process Using the Preset for Washing Using the Preset for Washing (continued) How to use the "PRESET" button (Switched options) Press the "START" button . Clothes not suitable for this mode. WIND DEHYDRATION Process Cleaning and pre-drying finish at one step WIND DEHYDRATION Process (continued) Washing of the "WIND DEHYDRATION" process AIR-JET Process Preparing for AIR-JET Provide the same drying effect as the airing in the room. Maximal 1.5kg of blending chemical fiber can be dried in 3 hours. 3 1.5kg Excessive use of detergent may cause insufficient air-jet or unexpected corrugations. AIR-JET Process (continued) Proposed Operation Time Shorten Laundry Airing Duration BASKET AIR-JET Process Maintenance of Washing Basket (BASKET AIR-JETBASKET CLEAN) AIR-JET Process (continued) BASKET CLEAN process is completed Maintenance of Washing Basket (BASKET AIR-JETBASKET CLEAN) (continued) BASKET CLEAN Process Use the Detergent Again 2 Use Guidelines Do not put in excessive clothes. Maintenance and Repair 6 Maintenance of nanometer titanium filter net Pay attention to the rust on the washing basket Maintenance of the detergent dispenser 1 Maintenance and Repair (continued) 2 4 Angle hole 6 Net pull down Convexity Hasp Protrusion Maintenance and Repair (continued) Maintenance to the main unit Warning How to maintain the water supply opening When Failure Happens About the abnormality alarm Flash of indicator Alarm content Part to check Solution Fail to supply water Fail to drain water Before the repair request Fail to running Flash of indicator Case Cause Alarm content Part to check Solution Page Automatic power OFF The following cases are not the failures Case Cause the water charging the sound Page drying time Case Cause the power switch lid lock Others Optional Parts Product Specifications Hitachi Appliances, Inc. No. 15-12, 2-chome, Nishi-Shinbashi, Minato-ku, Tokyo 105-8410, Japan Tel: Tokyo ( 03 ) 3502 - 2111