Case 現象
Fail to supply water 不供水
No spinning, washing basket can't rotate
不脫水、洗衣槽無法旋轉
No stirring
不攪拌
Unable to air-jet dry
無法風乾
It doesn't work after setting of air-jet dry
設定風乾後無法工作
Can not open the lid
機蓋打不開
Abnormal sound occurs
發出異常聲音
No buzz at the end of washing
洗衣結束後無蜂鳴聲
The lid can't be opened during the operation.
運轉過程中，機蓋無法打開
Water leakage
漏水
Water can not be reserved (when pouring the water with water basket)
不能儲水
（用水桶等容器倒入水時）
Cause 原因
Please refer to "Part to check" in "About abnormality alarm". 
57 請參照“關於異常警報”中的『檢查部位』。 
57
•Please refer to "The Approximate 
49
請參照“衣物的大致風乾時間”。 
49
•If there is water remained in the spinning basket, Start button can not be pressed. And it can only be pressed after draining all of the water.
脫水槽中有水積存時，就不能接受“動”鍵，要先進行排水，把水 排光後再按“動”。
•Is the power on?
(If there is outage and shutdown during the operation, the washing machine will generate alarms and cut off the power supply. The lid is still locked. When power supply is switched on again, the lid lock will be unlocked.)
電源開關是否打開?
（運轉過程中出現斷電或停電時，洗衣機將發出異常警報並自動切斷 電源，機蓋仍處於鎖定狀態。再次接通電源後，機蓋鎖定將解除。）
•Is the washing machine declining or shaky? 
7 Installation Guide
洗衣機是否有傾斜或搖晃? 
7 安裝指南
•Is any barrette or metal item mixed in the washing basket?
有無髮夾或金屬物體混入洗衣槽內?
•Is the buzz at the end of washing set as canceled? 
16
是否已設定取消洗衣結束蜂鳴聲? 
16
•Whether it is set to lid lock function (safety protection mode)? 
16
是否進行了機蓋緊鎖功能（安全保護模式）的設定? 
16
•Is the tap of proper shape? 
11
水龍頭的形狀是否合適? 
11
•Are the one touch joint and the connection nut unfastened? 
11, 12
便捷連接器和連接螺母是否出現鬆動? 
11, 12
•Is the power on?
電源開關是否打開?
(In case of power cut during draining, the drainage valve will keep open. And the drainage valve will close after the power resumes.)
（原因在於排水過程中出現斷電或停電時，排水閥會保持開狀態。 再次接通電源後，排水閥將關閉。）
•Except the failures metioned above, the lid lock protector may cause cases such as stop during operation or lid unable to be opened. In such case, please unplug the power supply unit. Plug it back after 5 minutes, and then reset operation.
除了上述故障外，如發生運行中途停止或機蓋無法打開的現象，是童鎖開關保護器動作。此時，請拔下電源插頭，五分鐘 後再插上，重新設定並運行即可。
59
