Hitachi C 10LA instruction manual Installing the Table Insert FIG. K, Power Cord FIG. M

English

INSTALLING THE TABLE INSERT (FIG. K)

The table insert has been previously installed on your unit. However, you must verify that the table insert is

flush with the table top surface on all four corners of the insert.

To avoid serious injury, the table insert must be level with the table. If the table insert is not fl ush with the table, adjust the four bolts (1) with a 4 mm hex. wrench until it is parallel with the table.

NOTE : To raise the insert, turn the hex screws counterclockwise, to lower the insert, turn the hex

Power Cord (FIG. M)

For convenience and to prevent damage to the power cord when the table saw is not in use or is being transported, the frame of leg has two brackets (1) on the side for cord storage.

Fig. M

screws clockwise.

Fig. K

1

1

MITER GAUGE ADJUSTMENT (FIG. N)

STORAGE (FIG. L, M)

Rip fence and miter gauge (Fig. L)

Storage brackets for the rip fence (1) and miter gauge (2) are located on the right side of the saw housing and frame of leg.

Fig. L

2

1.Make sure that the miter gauge bar (1) will slide freely through the table top grooves.

2.Loosen the lock knob handle (2) and turn the gauge body (3) to set the pointer (4) at 0O on the scale.

3.Make a 90O cut in a scrap piece of wood. Check the cut to see if it is 90O . If not, loosen the lock knob handle (2) and move the miter gauge body until it is square to the miter gauge bar by using a combination square.

MITER GAUGE OPERATION (FIG. N)

The miter gage is accurately constructed with index stops at 0O , 15O , 30O , 45O , 60O both right and left side.

The operate the miter gage, simply loosen the lock handle (2) and move the body of the miter gauge to the desired angle. The miter gauge body will stop at 0O , 15O 30O , 45O , 60O both right and left side.

Fig. N

1

1

3

2

4

– 16 –