2. Switch operation.
Lock-off | Hole |
Button | |
Handle | |
Trigger
Fig. 6
The trigger switch lock-off button is designed to prevent inadvertent operation of the power tool. To operate the power tool, it is necessary to first fully insert the lock-off button into the hole on the handle (see Fig.6).
The trigger switch will not operate unless the lock-off button has been pushed in.
When the trigger switch is released, the power goes off and the lock-off button automatically returns to its original position, locking the trigger switch.
WARNING: Always remove the lock-off button from the handle when the power tool is not in use. This will ensure that the power tool cannot be turned on accidentally, or by someone (especially a child) not qualified to use the power tool. If the lock-off button is left in the handle, serious personal injury could result. Since the lock-off button fits rather tightly, it may be necessary to turn it to the left and right during mounting and removing.
3.Cutting operation.
(1)Rotate the cut-off wheel, gently press down the handle, and bring the cut-off wheel close to the material to be cut.
(2)When the cut-off wheel contacts the material, gently press down the handle further and start cutting.
(3)When cutting (or designated slotting) is completed, raise the handle and restore it to its original position.
(4)At the termination of each cutting process, turn OFF the switch to stop rotation and proceed with the subsequent cutting job.
WARNING: Confirm that the trigger switch is turned OFF and that the power plug has been removed from the receptacle, whenever the tool is not in use.
Always remove the lock-off button from the handle, and store it in a secure place, after completing the work.
CAUTION:
●Increased pressure on the handle will not increase the cutting speed. On the contrary, too much pressure may result in overload of the motor and/or decreased cutting efficiency.
