Hitachi CDR-8130 General, Audio Performance, Reliability, Interface, Specifications

SPECIFICATIONS

GENERAL
Power Requirements DC Voltage		+12V		±10%	1.0A
		+5V		±5%	0.7A
Ripple		+12V		300 mVpp (maximum)
		+5V		150 mVpp (maximum)
Dimensions ( W x H x D )	146 x 41.3 x 190 mm (Excluding front panel)
	Front panel : 149.3 x 42.7 x 5 mm
Mass		0.95 kg
Operating & Storage Conditions
Temperature		5 - 45 °C		(operating)
		-30 - 60 °C		(non-operating)
Relative humidity		15 - 85% RH		(operating)
				(non-condensing)
		10 - 90% RH		(non-operating)
PERFORMANCE				(non-condensing)
Disc Diameter		120 mm, 80 mm
Rotational speed		71.3 - 52.7 s-1(Approx. 4,200 - 3,200 rpm)
Capacity (1M=220=1,048,576)		650 Mbytes (Mode 1)
		742 Mbytes (Mode 2)
		Conditions : 333,000 blocks (74 min.) for
Record Side		Single side		recorded area
Sustained Data Transfer Rate		1,200 - 2,400 kbytes/s			(Mode 1)
(1k=210=1,024)
Access Time
Average (1 / 3 - Stroke)		90 ms	(Typical) (Note 1)
Full Stroke		150 ms	(Typical) (Note 2)
Notes :

1)Average of 100 access operations, between 15-min 00-s 00-block and 35-min 00-s 00-block, with latency.

2)Average of 100 access operations, between 00-min 02-s 00-block and 59-min 59-s 74-block, with latency.

AUDIO PERFORMANCE
Number of Channels	2
Output Level	Line : 0.7 Vrms TYP. (47 kohms load)
	Headphone : 0.6 Vrms TYP. (32 ohms load)
Output Terminal	Line : 4-pin terminal (2.54 mm pitch)
RELIABILITY	Headphone out : ø3.5 mm Jack
	10-12or less
Data Error Rate		(Mode 1)*
	10-9or less	(Mode 2)*
* Raw error rate assumed to be 10-3or less.
INTERFACE	ATAPI - BUS
	40-pin non-shielded connector

Note

Design and specifications are subject to change without prior notice.

Hitachi has done everything possible to prevent the failure of the CDR-8130. However, it is not absolutely free from failure. In case it should fail, Hitachi is not responsible for the results.

12