Lamp (continued)
5 | Install the lamp cover and fix it using screws. |
∙ To prevent burn, install the lamp cover and secure it using screws. |
∙ When the lamp cover is out of place, the power does not turn on. Before you turn on the power, make sure to attach the lamp cover and fix it with the scrcws.
Whenever the lamp is replaced, reset the total operation time of the lamp.
Do not reset if the lamp has not been replaced.
2. Reset the lamp time
Please carry out the following operation within 10 minutes from power on, if you replaced the lamp after
2,000 hours.
ENGLISH
3
RIGHT |
|
| 3 |
RESET |
|
| |
STANDBY/ON |
| 2 | |
| MENU | ||
|
| ||
|
|
|
RESET
MENU
1, 2
1
| |
TIMER | VOL |
|
BLANK
MUTE INPUT
ON
LAMP TEMP
STANDBY/ON
1)Press the RESET button on projector for 3 seconds or remote control TIMER button for 3 seconds and display the total lamp used time.
∙When accumulated operation time of the lamp reaches 1700 hours, the following display will appear at the bottom of the screen.
2)Press the RESET button on projector or remote control MENU ON button during displaying the lamp used time.
3)Select the Ò0Ó on the screen using the MENU ( 
) button or MENU STICK SWITCH.
LAMP 1700 h
LAMP 1700 
→Ÿ0 
CANCEL
Message table
On-screen display
The following messages are displayed on the screen.
MESSAGE | Action |
|
|
|
|
CHANGE THE LAMP | Accumulated operation of lamp has exceeded 1,700 hours. It is recommended |
|
"AFTER REPLACING LAMP, | to replace lamp. Replace with new lamp. If accumulated operation reaches |
|
RESET THE LAMP TIMER." | 2,000 hours, lamp will automatically turn off. *1 |
|
CHANGE THE LAMP | Lamp has 1,979 hours on it. |
|
"AFTER REPLACING LAMP, | Call a maintenance person. *1 |
|
RESET THE LAMP TIMER." | Time is 20 ~ 0. (count down.) |
|
THE POWER WILL TURN |
|
|
OFF AFTER 20 Hr. |
|
|
|
|
|
Blinking of | When the lamp has 2,000 hours or more on it, the message will blink, and the |
|
"CHANGE THE LAMP" | power will turns off after 10 minutes. |
|
|
|
|
NO INPUT IS DETECTED | Signal is hot input. (See page 18, 19) |
|
|
|
|
SYNC IS OUT OF RANGE | The horizontal frequency of the input signal exceeds the range of the projector, |
|
it cannot be displayed. (See page 19, 20) |
| |
|
| |
|
|
|
CHECK THE AIR FLOW | Clean the air filter of remove the blocking ventilation holes. (See page 27) |
|
|
|
|
*1 This message are not displayed after 3 minutes. | 29 | |
But this message are displayed when you turn on the power again. | ||
