Lamp
Light source lamp has a service life.
The picture will become dark or color will be poor when the lamp is used for a long time.
If usage of lamp is continued in such cases, it could cause a malfunction. Replace lamp with new one.
As reference for replacement time, indicator will operate or message will be displayed when the power is turned on, as shown on page 29~30. In these cases the lamp should be replaced. Consult your dealer.
Caution | Also LAMP indicator will light when the lamp becomes too hot. Turn off the power and let the | |
projector cool for 45 minutes. Turn on. If LAMP indicator still lights up red, contact your | ||
| ||
| dealer. |
1. How to replace lamp | (Option lamp : Lamp unit |
| |
| HIGH VOLTAGE |
| HIGH TEMPERATURE |
| HIGH PRESSURE |
When replacing lamp, turn off and remove AC cord, wait 45 minutes to let lamp cool.
Caution | ∙ For disposal of used lamp, treat according to the instruction of community authorities. |
∙Since the lamp is made of glass, do not apply shock to it and do not scratch it.
∙Also, do not use old lamp. This could also cause explosion of the lamp.
∙If it is probable that the lamp has exploded
(explosive sound is heard), disconnect the power | Reflector |
| Front glass |
| |||
plug from the power outlet and ask your dealer to |
|
|
|
replace lamp. The lamp is covered by front glass |
|
|
|
and |
|
| Lamp |
reflector and the inside of the projector may be |
|
| |
damaged by scattered broken pieces of glass, and |
|
|
|
broken pieces could cause injury when being handled. |
|
|
|
1 | Turn the main power switch off and disconnect the power | ||
| plug from the power outlet. |
|
|
2 | Remove the lamp cover. |
|
|
∙ If lamp is hot at this time, this could cause burn. Wait |
|
| |
| for about 45 minutes until lamp is cooled down. | Screw | Lamp cover |
| ∙ Loosen a screw and remove the cover. | ||
|
|
| |
3 Loosen two screws and pull
the handle to remove the
lamp.Screw
∙ If the screws are not loosened completely, your fingers | Lamp | |
may be damaged. | ||
|
∙Do not insert your hand into the box after the lamp is removed.
(There are optical parts inside. If touched by hand, it may result in color unevenness, etc.)
4 Replace the lamp with new one and fix it using the same two screws.
28
