Facility names and functions (Rear)

13HIGH SPEED OUTPUT connectors (BNC)

Outputs 2 sets of three times high speed signals as LINK A, LINK B and LINK C.

[1080i, 720p]

14HD SDI connectors (BNC)

Outputs two lines of digital serial HDTV video signals. A trunk video output (1080i) can be selected by CCU menu.

[1080i, 720p]

15 HD/SD SDI connectors (BNC)

Outputs six lines of digital serial HDTV/SDTV video signals.

[1080i, 720p, SD]

The character is superimposed in PIX output.

16 D.RET input connectors (BNC)

Input digital serial AUX video signals. RET.A: Normal Return Signal

Output from the camera viewfinder or the camera’s RET connector.

Selected by 4-position RET SEL switch on CA-HF1500 and CCU menu.

RET.B: Continuous Return Signal

Output from HD-SDI2 connector on CA-HF1500.

Selected by only CCU menu.

Important notice

When using return video, please input correct format signal, which is selected on the return assignment menu (page 13).

17 PROMPT connectors (BNC)

Input analog video signal for the prompter. The signal is sent to PROMPT out connector on CA-HF1500.

18 Genlock connectors (BNC)

Input tri-level sync signal or black burst signal for genlock operation.

19 REMOTE 1,2,3 connector

Connect the optional camera control panel or setup control unit.

20Fiber connector Connect Fiber cable.

21AC IN connector

Input for AC power supply.

22 FG terminal

Frame ground terminal.

23 MIC OUT1 connector (XLR 3 pin)

Outputs MIC1 audio signals from a camera or the CA-HF1500 at 0 dBm/600 ohm.

24 MIC OUT2 connector (XLR 3 pin)

Outputs MIC2 audio signals from the CA-HF1500 at 0 dBm/600 ohm.

25 MIC REMOTE connector

This connector is used to select the MIC1 and MIC2 amplifier gains.

5

Page 19
Image 19
Hitachi CU-HD1500 operating instructions Facility names and functions Rear, Important notice