Hitachi DH 30PC2 APPLICATIONS, PRIOR TO OPERATION, Fig, Fig, NOTE, CAUTION, CAUTION:, (Fig. 1), CAUTION:, drill bit, Power source, Power switch, Mounting the, the driver bit

English

13 mm drill chuck ass’y (includes chuck wrench) and chuck (for drilling in steel or wood).

10. Driving Screws (rotation only)

Bit No.	Chuck adapter (D)
	(SDS-plus shank)
Bit No.	Screw Size	Length
No. 2	3 – 5 mm	25 mm
No. 3	6 – 8 mm	25 mm

11.Hammer grease A 500 g (in a can)

70 g (in a green tube)

30 g (in a green tube)

Optional accessories are subject to change without notice.

APPLICATIONS

(1)

Clean the shank portion of

the

drill bit.

(2)

To attach a drill bit (SDS-plus shank), fully pull the

Rotation and hammering function

grip in the direction of the arrow as shown in Fig.

1 and insert the drill bit as far as it will go while

Drilling

anchor holes

manually turning.

Drilling

holes

in

concrete

(3) By releasing the grip, the drill bit will be secured.

Drilling

holes

in

tile

(4)

To remove

the

drill bit, fully pull the grip in

the

Rotation only function

direction

of

the

arrow and pull

out the drill

bit.

Drilling

in steel

or wood

5.

Installation of dust cup (Optional accessories) (Fig.

(with optional

accessories)

2)

Tightening machine

screws,

wood

screws

When using a rotary hammer for upward drilling

(with optional

accessories)

operations

attach

a dust cup to collect dust or

Hammering only function

particles

for

easy

operation.

Light-duty chiselling of

concrete,

groove

digging

Installing

the

dust

cup

and edging.

Use the dust cup by attaching to the drill bit as

shown in Fig. 2.

PRIOR TO OPERATION

When using a bit which has big diameter, enlarge

1.

Power source

the center hole

of the dust

cup with this rotary

hammer.

Ensure that the power source to be utilized conforms

CAUTION:

to the power requirements specified on the product

The dust cup is for exclusive use of concrete drilling

nameplate.

work. Do not use them for wood or metal drilling

2.

Power switch

work.

Ensure that the power switch is in the OFF position.

Dump particles after every two or three holes when

If the plug is connected to a receptacle while the

drilling.

power switch is in the ON position, the power tool

6.

Selecting

the driver bit

will start operating immediately, which could cause

Screw heads or bits will be damaged should an

a serious accident.

inappropriate bit for the screw diameter be employed

3.

Extension cord

to drive

in

the

screws.

When the work area is removed from the power

7.

Selecting the function mode

source, use an extension cord of sufficient thickness

You can

switch

functions

to

the 3 modes of

and rated capacity. The extension cord should be

“hammering

only,

“rotation

+

hammering”,

and

kept as

short

as

practicable.

“rotation only” by turning the change lever while

4.

Mounting the

drill bit

(Fig. 1)

pressing the push button. Set the ▲ mark position

CAUTION

of the change lever to that of the mode to be used.

To prevent accidents, make sure to turn the switch

CAUTION:

off and

disconnect the

plug from

the receptacle.

Before operating the change lever, check and make

NOTE	sure that the motor has stopped.
When using tools such as bull points, drill bits, etc.,
	A failure can occur if it is operated while the motor
make sure to use the genuine parts designated by
	is running.
our company.

9