Multifunctional settings
OPTION Menu
With the OPTION menu, items shown in the table below can be performed.
Select an item using the cursor buttons ▲/▼ on the projector or remote control, and press the cursor button ► on the projector or remote control, or the ENTER button on the remote control to progress, except for the items LAMP TIME and FILTER TIME. Then perform it referring to the following table.
MENU [RGB] |
| :SELECT |
PICTURE | SEARCH | TURN ON |
IMAGE | AUTO OFF | 0 |
INPUT | LAMP TIME | 0 |
SETUP | FILTER TIME | 0 |
SCREEN | SERVICE |
|
OPTION |
|
|
EASY MENU |
|
|
Item |
| Description | |
|
| ||
| Using the buttons ▲/▼ turns on/off the automatic signal search | ||
| function. |
| |
| TURN ON TURN OFF |
| |
SEARCH | When the TURN ON is selected, detecting no signal automatically | ||
cycles through input ports in order of following. Then when an input | |||
| |||
| is found, the projector will stop searching and display the image. | ||
| RGB IN1 RGB IN2 COMPONENT VIDEO | ||
|
| ||
| Using the buttons ▲/▼ adjusts the time to count down to | ||
| automatically turn the projector off. | ||
| Long (max. 99 minutes) Short (min. 0 minute = DISABLE) | ||
| AUTO OFF | AUTO OFF | |
| ENABLE | DISABLE | |
AUTO OFF | 1 | 0 | |
When the time is set to 0, the projector is not turned off | |||
| |||
| automatically. |
| |
| When the time is set to 1 to 99, and when the passed time with | ||
| a | ||
| projector lamp will go off and the power indicator begins blinking. | ||
| |||
| The lamp time is the time counted after the last resetting. It is | ||
| shown in the OPTION menu as the use time of the lamp. | ||
| Pressing the RESET button on the remote control for about 3 | ||
| seconds displays a dialog. To reset the lamp time, select the | ||
LAMP TIME | RESET using the button ▲. |
| |
RESET CANCEL |
| ||
|
| ||
| • Please reset the lamp time only when you have replaced the lamp, | ||
| for correct messages about the lamp. | ||
| • About the lamp replacement, please see the section "Lamp" ( | ||
| 38, 39). |
|
36