Setting up

About the filter cover for bottom-up use

WARNING ►Do not replace the filter cover during use or immediately after use. While the projector connects with a power supply, or the projector is in a high temperature state, handling could cause an electric shock, a fire, a burn and/or malfunction to the projector.Before handling, make sure the power switch is off and the power cord is not plugged in, then wait at least 45 minutes.

When the projector is installed bottom up, please use the accessory filter cover for bottom-up use. It is higher than usual filter cover, to keep the space for intake ventilation. Please change in the following procedure.

Filter cover’s knob

Filter cover’s knob

 

 

To remove

To set

Filter cover

Filter cover for bottom-up use

 

1. After making sure that the projector is cool adequately, slowly turn the projector so that the lens-side is facing up. Please be careful for a projector

not to fall. While the projector is placed lens-side up, hold the projector.

2. Putting a finger on the filter cover’s knob, slide the filter cover in the direction of the arrow to remove it.

3. Replace the filter cover for bottom-up use and snap it back into place.

4. Slowly turn the projector so that the top is facing up.

9