Filling Water Tank (for Humidify Mode and Skin Moisturize Modes)
Gently remove the water tank.
While pressing the upper part of the water tank handle, lift it obliquely upward, and remove the water tank by supporting it in the bottom.
Handle
Hold the water tray.
| Do not carry the water tank by holding its |
| handle. Instead, hold the tank with both |
CAUTION | hands and carry it while keeping the tank |
| cap side up. When the water tank is wet, |
| wipe off water drops before carrying. |
|
|
Remove the tank cap and fill fresh tap water of normal temperature.
Rubber packing
Check that the tank cap is equipped with a rubber packing.
Do not push in the
| Loosen |
| pin in the cap center. |
|
| Tighten | |
|
| Doing so may cause | |
|
|
| |
|
|
| water leakage. |
Handle |
|
| Pin |
|
|
|
Press the center pin of the tank cap, and check that it comes back by spring.
Tighten the tank cap firmly, wipe off spilt water, and check that there is no water leakage.
Wipe off water on the water tank handle if any.
The tank cap is a consumable part.
(If it leaks water due to deteriorated rubber packing, please purchase separately available part for replacement.)
Preparations for Operation Installation
Pull out the water tray, check that the humidifying filter and tray cover are equipped, and then retract the tray.
The humidifying filter absorbs water supplied from the water tank for humidifying operation.
Humidifying filter
Water tray
Set the water tank into the water tank holder.
Be sure to handle the
Tray cover |
|
|
Water tray |
| When you remove the water tank, water may |
|
| |
Slowly pull out the water tray while lifting it | CAUTION | drip from the tank cap. Lay a dry cloth before |
obliquely upward. |
| removing the water tank. |
Do not set the water tank without having the water tray in place. Otherwise, the water tank may tip over.
When you pull out the water tray, be careful not to scratch the floor with bottom of the tray. CAUTION Do not leave the detached water tank with its cap closed.
Inner pressure of the tank changes according to ambient temperature change and may cause water leakage or injury due to deformation or damage.
Note | Humidifying function works automatically when the water tank and water tray are filled with water. | |
If you do not need humidification, operate the unit without filling water in the water tank and water tray. | ||
|
Installation
Install the purifier on a level, stable and sturdy surface.
Avoid any place close to cooling or heating appliance, and select a
Keep the purifier at least 90 cm away from the walls in both sides. Otherwise, discharged air will mix with surrounding air and the walls may become dirty.
WARNING | Do not place the purifier on unstable floor or pedestal. |
Falling or dropping of the purifier may cause damage, failure or water leakage. | |
| Using the purifier in an inclined position may cause water leakage. |
|
|