Preparations for Operation
CAUTION
Lay a soft cloth or the like beneath the purifier to protect the floor against scratch.
No cleaning effect is obtainable if the filter is installed with plastic bag. It may also be a cause of malfunction. Do not tip over or tilt the purifier.
Setting Filter in Purifier (Perform the same procedure when replacing filter.)
Remove the panel.
Place the unit on a level, stable surface.
Hold the panel at both sides, pull it gently forward and then slightly upward, and remove it.
Remove the pre-filter.
Disengage the tabs of the
Remove the filter.
Remove the filter packed in a plastic bag from inside the unit.
Take the filter out of a plastic bag.
Remove the packing.
Be sure to remove the packing.
Install the filter.
Install the filter on the unit.
Install the filter so that the arrow “ FRONT” on the filter side face will face the panel.
Install the pre-filter.
White face of
Filter the filter should face the front.
Engage the tabs of the
Note | Be sure to take out the filter from a plastic bag. |
| Do not block the filter front face with cloth or paper. |
|
|
Reinstall the panel on the unit.
Insert the two tabs on top of the |
|
panel into the two holes on the unit. |
|
Gently push bottom of the panel until |
|
it clicks to close it securely. | Insert into the hole. |
To avoid having difficulty in installing the panel, do not push the panel with a single hand or do not push it anywhere except its bottom.
Inserting Batteries into Remote Controller
Remove the battery compartment cover.
Cover
Insert batteries and close the cover.
Insert the provided two “AAA” R03 batteries
with the correct polarities as instructed. Since the batteries are provided when shipped from
the factory, their lives may be shorter than
ones because of
When replacing batteries, replace the two batteries simultaneously. Only use two manganese batteries or two alkali batteries. Do not mix them.