Hitachi hitachi air purifier with humidifying function Starting Operation, Press button, E-10

Using Remote Controller

Here we describe how to operate the air purifier using the remote controller. For the operation using the control on the purifier, please refer to page E-13.

Starting Operation

Remote Controller	Air Purifier
On/Off Mode Airflow

Timer

Max Sensor

Setting

Indicator Section

On/Off

				(Approx.)
Humidity Level
			Strong	Max(Blinking) Air	Clean
(Green)					Humidifying
	Air Purify	Pollen	Deodorization Auto	Sensor	Filter
(Orange)	Humidify	Skin	Timer (4hrs)
		Moisturize

Securely insert the power plug into AC outlet.

On/Off

Press button.

In the first 3 minutes after the power cord is plugged in, the unit will check room air condition and save

it in memory. During the time, the “Air Sensor” indicator and “Humidity Level 50” indicator will blink.

You may start the operation in less than 3 minutes after plugging. In this case too, the “Air Sensor” and “Humidity Level 50” indicators will continue to blink. After 3 minutes, the indicators will stop to blink and show the level of air contamination and humidity.

Blink

Blink

Operation starts and the indicators are lit.

The “Air Purify” mode indicator is lit in green. *

On/Off

Pressing button during operation will stop the operation.

(Orange)

Lit ingreen

Note

If On/Off button is not pressed after plugging the power cord, all indicators will go off after the “Air Sensor” and “Humidity Level 50” indicators blink for 3 minutes. (Remote controller operation is accepted even in this state.)

* The factory setting is “Air Purify”.

From the second time onward, the memory function enables the operation with memorized conditions. P.E-14

Stand-by Power Consumption

So long as the power plug is left inserted in AC outlet, approx. 3W power will be consumed even if the unit is not used. (Unplug the power cord when the unit is left unused for an extended period of time.)

E-10