Camera mounting

Attached optional accessory the tripod adaptor "TA-FD140", mount the camera to a tripod or mounting bracket.

Screw type: Ｕ1/4-20

 

L

Length Ｌ = 4 to 5.5mm

 

 

 

 

Screws longer than 5.5 mm can cause internal damage, while less

 

 

 

 

than 4 mm prevents secure fastening and risks dropping to cause

 

 

 

 

damage and injury.

Lens

CAUTION

Observe the dimensions of the lens mounting selection as illustrated at the right.

If the dimensions are not observed, do not use such a lens, because the lens and the camera will be damaged.

Lens opticsLens flangeMax 9mm

Flangeback adjustment is needed in cases where focus cannot be obtained by normal lens focus operation or focus is lost at the maximum telephoto and wide angle settings of a zoom lens. In such cases, open the lens iris and adjust as follows.

1）Fixed focus lens1.Set the lens focus ring to infinity.2.Aim toward an object at least 20 meters distant.

3.Loosen the 2 lens mount screws and turn the lens mount ring to adjust the focus. Use care not to disturb the lens focus ring.

4.Tighten the lens mount screws.2）Zoom lens

1.Set the lens to telephoto and aim toward an object at least 20 meters distant.

2.Turn the lens focus ring to adjust the focus.

3.Set the lens to wide angle. Loosen the 2 Lens mount screws and turn the lens mount ring to adjust the focus. Use care not to disturb the lens focus ring.

4.Again set to telephoto but adjust the focus by turning the lens mount.5.Repeat these steps and carefully adjust for best focus.6.Finally, tighten the lens mount screws.

Note

If using an auto iris lens and the adjustment object distance is less than several meters, due to lens depth of focus relationship, slight blurring can occur at certain iris positions.

In this event, darken the scene so as to open the iris and adjust the focus or flangeback to prevent the blurring.

3