English

AIR SUPPLY

DANGER

NEVER use oxygen or other bottled gases. Explosion may occur.

WARNING

Never connect Nailer to pressure which potentially exceeds 200

psi (13.7 bar 14 kgf/cm2).

Never use non relieving coupler on Nailer.

1.Power source

Use only clean, dry, regulated compressed air as a power source for this Nailer.

Air compressors used to supply compressed air to this Nailer must comply with the requirements of the latest version of ANSI Standard B 19.3 “Safety Standard For Compressors For Process Industries.”

Moisture or oil in the air compressor may accelerate wear and corrosion in the Nailer. Drain daily.

2. Filter-Regulator-Lubricator

 Use a regulator with a pressure range of 0 – 120 psi (0 – 8.3 bar 0 – 8.5 kgf/cm2).

Filter-regulator-lubricator units supply an optimum condition for the Nailer and extend

the Nailer life. These units should always be used.

Filter

The filter removes moisture and dirt mixed in compressed air.

 

Drain daily unless fitted with an automatic drain.

 

Keep the filter clean by regular maintenance.

Regulator

The regulator controls the operating pressure for safe operation of the

 

Nailer.

 

Inspect the regulator before operation to be sure it operates properly.

Lubricator

The lubricator supplies an oil mist to the Nailer.

 

Inspect the lubricator before operation to be sure the supply of lubricant

 

is adequate.

 

Use Hitachi pneumatic tool lubricant.

 

Regulator

Nailer side

Compressor side

 

Filter

 

Lubricator

11