English

COLD WEATHER CARE

Do not store the Nailer in a cold weather environment. Keep the Nailer in a warm area until beginning the work.

If the Nailer is already cold, bring it in a warm area and allow the Nailer to warm up

before use.

1 Reduce the air pressure to 70 psi (4.9 bar 5.0 kgf/cm2).

2Remove all nails from the Nailer.

3Connect the air hose and free-fire (blank-fire) the Nailer.

The lowered air pressure will be enough to free-fire the Nailer. Slow speed operation tends to warm up the moving part.

CAUTION:●Do not free-fire the Nailer at high pressure.

TESTING THE NAILER

DANGER

●Operators and others in work area

MUST wear safety glasses with side shields which conforms to ANSI Z87.1 specifications.

WARNING

●Never use Nailer unless push lever is operating properly.

Before actually beginning the nailing work, test the Nailer by using the check list below. Conduct the tests in the following order.

If abnormal operation occurs, stop using the Nailer and contact a Hitachi authorized service center immediately.

(1)DISCONNECT AIR HOSE FROM NAILER. REMOVE ALL NAILS FROM NAILER.

ALL SCREWS MUST BE TIGHTENED. If any screws are loose, tighten them.

13