English
(2) Adjust the air pressure to 70 psi (4.9 bar 5 | ||
kgf/cm2). |
|
|
Connect the air hose. |
| |
Do not load any nails in the Nailer. | ||
Set the switching device to the upward | ||
position | (SINGLE | ACTUATION |
MECHANISM). |
| |
(Set the switching device to the upward | ||
position completely as shown in the | ||
diagram. Otherwise, it will not operate | ||
properly.) |
|
|
| Upward position | |
| Switching Device | |
□The nailer must not leak air.
(3)Remove the finger from the trigger and press the push lever against the wood.
□The nailer must not operate.
Depress | Do not pull Trigger |
Push | |
Lever |
|
(4)Separate the push lever from the wood. Next, point the nailer downward, pull the trigger and then wait in that position for 5 seconds or longer.
□The nailer must not operate.
Pull Trigger
(5)1 Without touching the trigger, depress the push lever against the workpiece. Pull the trigger.
□The nailer must operate.
2Hold the trigger back while separating the push lever from the wood.
□The nailer will remain in operated status (the driver blade will remain at the bottom).
3Remove the finger from the trigger.
□Nailer operation will end (the driver blade will return to the top).
(6)Set the switching device to the downward
position (CONTACT ACTUATION MECHANISM).
(Set the switching device to the downward position completely as shown in the diagram. Otherwise, it will not operate properly.)
Downward position
Switching
Device
With the Nailer off the workpiece, pull the trigger.
Depress the push lever against the workpiece.
□The nailer must operate.
11