English
(7)If no abnormal operation is observed, you may load nails in the Nailer.
Drive nails into the workpiece that is the same type to be used in the actual application.
□ The nailer must operate properly.
Adjusting air pressure
WARNING
(2)Slide the nail strip forward in the magazine. The nail strip should pass the nail stopper.
●Do not exceed 120 psi (8.3 bar 8.5 kgf/cm2).
Adjust the air pressure at recommended operating pressure 70 – 120 psi (4.9 – 8.3 bar 5 – 8.5 kgf/cm2) according to the length of nails and the hardness of workpiece.
The correct air pressure is the lowest pressure which will do the job. Using the Nailer at a higher than required air pressure unnecessarily over stresses the Nailer.
Loading nails
WARNING
●When loading nails into the nailer, be sure to remove your finger from the trigger and disconnect the air hose from the nailer.
(1)Insert nail strip into rear of magazine.
Magazine
12
Nail Stopper
(3)Pull the nail feeder (B) back to engage the nail feeder (A) to the nail strip.
Nail Feeder (B)
Nail Feeder (A)
NOTE
○ Use nail strip at least 5 nails remaining.
The Nailer is now ready to operate.
Removing the nails:
1Depress the nail feeder (A) slightly and slowly slide the nail feeder (B) forward.
Remove the nails from the Nailer.2
2
1 Nail Feeder (A)